Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 012-291 — Xerox WorkCentre 5330

Code: 012-291

Description: Stapler Failure RAP (LX) • After the Stapler Motor turned On (Forward rotation), the Staple Head Home Sensor did not switch from Off to On within the specified time. • After the Stapler Motor turned On (Reverse rotation), the Staple Head Home Sensor did not turn On within the specified time.
Remedy: Execute Component Control [012-046], Staple Motor FWD, and [012-047], Staple Motor REV. The Stapler cycles. Y↓N→Check the wires between J8887, pins 1~4 on the Stapler Assembly and P/J8981 pins 9~12 on the Finisher PWB for an open or short circuit, or loose or damaged connectors. If the wires are OK, the Stapler Assembly (PL 23.8). If the problem continues, replace the Finisher PWB (PL 23.16). Select Stop. Execute [012-244], Staple Home Sensor. The display is “Low.” Y↓N→There is +5 VDC from pin 5 to pin 1 of J8886 on the Stapler Assembly. Y↓N→Check the wires from P/J8981, pins 4 and 8, to J8886 pins 5 and 1 for an open circuit. If the wires are OK, replace the Finisher PWB (PL 23.16). Check the wire from J8886 pin 4 to P/J8981 pin 5 for an open circuit. If the wire is OK, replace the Stapler Assembly (PL 23.8). Go to BSD 12.21 - Office Finisher LX Staple Control Check for an intermittent connection. If the check is good, replace the Stapler Assembly (PL 23.8). If the problem continues, replace the Finisher PWB (PL 23.16).

← Xem tất cả mã lỗi Xerox WorkCentre 5330

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie