Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 012-296 — Xerox WorkCentre 5330

Code: 012-296

Description: Staple Move Sensor Off Failure RAP (LX) • After the Stapler started moving to the Staple Position and the Staple Move Sensor turned Off, the Staple Move Sensor did not turn Off within 500ms. • After the Staple Position had been fixed, the Staple Move Sensor turned Off. • After the Staple Move Sensor turned On when paper passed through the Dual Staple 1 Position while moving to the Rear Staple Position, the Staple Move Sensor did not turn Off within 500ms.
Remedy: Execute Component Control [012-241], Stapler Move Position Sensor. Move the Stapler by hand from the Home position to the staple position and back. The display changes. Y↓N→Check the wire between J8885 pin 2 on the Stapler Move Position Sensor and P/J8981 pin 2 on the Finisher PWB for an open or short circuit, or loose or damaged connectors. The wire is OK. Y↓N→Repair/replace as required. Measure the voltage between P/J8981, pins 3 and 1 on the Finisher PWB BSD 12.20 - Office Finisher LX Staple Positioning. The voltage is approx. +5VDC. Y↓N→Replace the Finisher PWB (PL 23.16). Measure the voltage between P/J8981 pin 2 on the Finisher PWB and GND BSD 12.20 - Office Finisher LX Staple Positioning). Move the Stapler by hand from the Home position to the staple position and back. The voltage changes. Y↓N→Replace the Stapler Move Position Sensor (PL 23.8). Replace the Finisher PWB (PL 23.16). Alternately execute Component Control [012-045], Staple Move Motor Rear and [012-042], Staple Move Motor Front. The Stapler Move Motor moves. Y↓N→Check the wires between P/J8981 pins 13~16 on the Finisher PWB and P/J8888 on the Stapler Move Motor BSD 12.20 - Office Finisher LX Staple Positioning for an open or short circuit, or loose or damaged connectors. The wires are OK. Y↓N→Repair/replace as required. Replace the Staple Move Motor (PL 23.8). If the problem persists, replace the Finisher PWB (PL 23.16). Go to BSD 12.20 - Office Finisher LX Staple Positioning Check for an intermittent connection. If the check is good, replace the Stapler Assembly (PL 23.8). If the problem continues, replace the Finisher PWB (PL 23.16).

← Xem tất cả mã lỗi Xerox WorkCentre 5330

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie