Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 012-935 — Xerox WorkCentre 5330

Code: 012-935

Description: (Integrated Finisher) Paper Remains at Entrance Sensor RAP • At Power On the Finisher Entrance Sensor detected paper. • While the Main Motor was operating at initialization at Power On, the Finisher Entrance Sensor detected paper. • When the Cycle down operation at the end of a job was complete, the Finisher Entrance Sensor was On.
Remedy: Check for paper remaining on the Finisher Entrance Sensor and how it is installed. The sensor is properly installed and free from paper. Y↓N→Remove the remaining paper and reinstall the sensor properly. Enter Component Control [012-140]. Move the Finisher Entrance Sensor actuator by hand or with a piece of paper. The display changes. Y↓N→Check the connections of P/J8709 and P/J8729. P/J8709 and P/J8729 are securely connected. Y↓N→Connect P/J8709 and P/J8729 securely. Check for an open or short circuit between P/J8709 and P/J8729. The wire between P/J8709 and P/J8729 are OK. Y↓N→Repair the open or short circuit. Measure the voltage between P/J8709-6 (+) on the Finisher PWB and GND (-). The voltage is approx. +5VDC. Y↓N→Go to Integrated Finisher Wirenets and check the +5VDC circuit. Measure the voltage between P/J8709-5 (+) on the Finisher PWB and GND (-). Actuate the Finisher Entrance Sensor. The voltage changes. Y↓N→Replace the Finisher Entrance Sensor (PL 22.5). Check the wires and connectors for an intermittent open or short circuit. If the problem continues, replace the Finisher PWB (PL 22.7). Check the wires and connectors for an intermittent open or short circuit. If the problem continues, replace the Finisher PWB (PL 22.7).

← Xem tất cả mã lỗi Xerox WorkCentre 5330

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie