Code: 077-109
Description: Exit Sensor 2 On Jam RAP After the Fuser Exit Sensor turned ON, the Exit 2 Sensor did not turn ON within the specified time.
Remedy: Check the following: • A paper transportation failure due to a foreign substance/burr on the paper path • Each Exit Roll and Pinch Roll for contamination, wear, and revolution failure • The Fuser for wound up, stuck paper • Each Exit Roll Drive Gear for wear and damage • The Exit 1 Gate for operation failure • Use of paper out of spec • The Exit 2 Sensor for contamination, improper installation, and Actuator operation failure
Check the following: • The Exit 2 Sensor for failure: Component Control [077-100] (PL 17.4) • The connection between the Exit 2 Sensor P/J115 and the MCU PWB P/J411 for open circuit, short circuit, and poor contact • The Exit 2 Motor for revolution failure: Component Control [077-015] (PL 17.5) • The Exit Gate Solenoid for failure: Component Control [077-004] (PL 17.4) Reload the machine software (GP 16). If no problems are found, replace the MCU PWB (PL 18.2).
Check the following: • The Exit 2 Sensor for failure: Component Control [077-100] (PL 17.4) • The connection between the Exit 2 Sensor P/J115 and the MCU PWB P/J411 for open circuit, short circuit, and poor contact • The Exit 2 Motor for revolution failure: Component Control [077-015] (PL 17.5) • The Exit Gate Solenoid for failure: Component Control [077-004] (PL 17.4) Reload the machine software (GP 16). If no problems are found, replace the MCU PWB (PL 18.2).