Code: 078-100
Description: Tray 6 (HCF) Pre Misfeed RAP Tray2 Pre Feed Sensor is not turned ON by the paper in specified time from Tray 2 Feed Start.
Remedy: Execute Component Control [078-100], Tray 6 Pre Feed. Sensor. Block and unblock the Sensor. The display changes. Y↓N→The connection between the Tray 6 Pre Feed. Sensor PF/JF61 and the HCF PWB PF/ JF02 for open circuit, short circuit, and poor contact. If OK, replace the Tray 6 Pre Feed. Sensor (PL 10.5) Open and close Tray 6. The Tray 6 Lift/Feed Motor operates Y↓N→Check the circuit between PF/JF58 on the Tray 6 Lift/Feed Motor and PF/JF06 on the HCF PWB for an open or a short circuit, or a loose or damaged connector. The wires are OK. Y↓N→Repair as required. Check that the resistance through Tray 6 Lift/Feed Motor is approx. 0.8 ohms at the measurement points below. • PF/JF58-3 to pins 1/2 • PF/JF58-4 to pins 5/6 The resistances are OK+ Y↓N→Replace the Tray 6 Lift/Feed Motor (PL 10.4). There is +24VDC from PF/JF06 pins 3 and 4, to GND. Y↓N→Go to IOT wirenets and troubleshoot the +24VDC circuit. Replace the Tray 6 Lift/Feed Motor (PL 10.4). If the problem persists, replace the HCF PWB (PL 10.8). Check the following: • The Tray 6 Pre Feed Sensor for failure: Component Control [078-100] (PL 10.5) • The Tray 6 Feed/Lift Motor failure: Component Control [078-003] CW (PL 10.4) • The Tray 6 In Sensor failure: Component Control [078-204] CW (PL 10.1) • The connection between the Tray 2 Pre Feed Sensor PF61 and the HCF PWB PF02 for open circuit, short circuit, and poor contact Reload the machine software (GP 16). If no problems are found, replace the MCU PWB (PL 18.2).