Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 078-104 — Xerox WorkCentre 5330

Code: 078-104

Description: HCF Feed Out Sensor Fault RAP The paper transported from HCF did not turn on the Tray 6 Feed Out Sensor within the specified time.
Remedy: Execute Component Control [078-101], Tray 6 Feed out Sensor. Block and unblock the Feed Out Sensor. The display changes. Y↓N→Go to BSD and check the following for an open wire, short or poor contact: • Feed Out Sensor PF/JF67-1 to HCF PWB PF/JF01-3 • Feed Out Sensor PF/JF67-3 to HCF PWB PF/JF01-1 • Feed Out Sensor PF/JF67-2 to HCF PWB PF/JF01-2 If OK, replace the Feed Out Sensor (PL 10.8) before replacing the HCF PWB (PL 10.8). Execute Component Control [078-093], Tray 6 Takeaway Motor. There is operation noise from the Takeaway Motor. Y↓N→Check the circuit between PF/JF57 on the Tray 6 Takeaway Motor and PF/JF06 on the HCF PWB for an open or a short circuit, or a loose or damaged connector. The wires are OK. Y↓N→Repair as required. Check that the resistance through Tray 6 Takeaway Motor is approx. 0.8 ohms (at 25 degrees C / 77 degrees F) at the measurement points below. • PF/JF57-3 to pins 1/2 • PF/JF57-4 to pins 5/6 The resistances are OK Y↓N→Replace the Tray 6 Takeaway Motor (PL 10.8). There is +24VDC from PF/JF06 pins 9 and 10, to GND. Y↓N→Go to IOT wirenets and troubleshoot the +24VDC circuit. Replace the Tray 6 Takeaway Motor (PL 10.8). If the problem persists, replace the HCF PWB (PL 10.8). Check the HCF Take Away components and repair as required (PL 10.4).

← Xem tất cả mã lỗi Xerox WorkCentre 5330

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie