Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 012-151 — Xerox WorkCentre 5335

Code: 012-151

Description: Compiler Exit Sensor Off Jam RAP (LX) After the Compiler Exit Sensor turned On, the Compiler Exit Sensor did not turn Off within the specified time.
Remedy: Execute Component Control [012-150], Compiler Exit Sensor. Actuate the Compiler Exit Sensor (PL 23.14). The display changes. Y↓N→Check the wire between J8869 pin 2 and P/J8988 pin 5 for an open or short circuit, or a loose or damaged connector. The wire is OK. Y↓N→Repair/reconnect as required. Measure the voltage between P/J8988, pins 6 and 4 on the Finisher PWB. The voltage is approx. +5VDC. Y↓N→Replace the Finisher PWB (PL 23.16). Measure the voltage between P/J8988, pin 5 on the Finisher PWB and GND. Actuate the Compiler Exit Sensor. The voltage changes. Y↓N→Replace the Compiler Exit Sensor (PL 23.4). Replace the Finisher PWB (PL 23.16). Execute Component Control [012-038], Transport Motor. The Transport Motor rotates. Y↓N→Check the wires between P/J8879 on the Transport Motor and P/J8983 on the Finisher PWB for an open or short circuit, or a loose or damaged connector. The wires are OK. Y↓N→Repair/reconnect as required. Measure the resistance of the Transport Motor between each pin P/J8879-1/2/5/6. The resistance is approx. 20 Ohm. Y↓N→Replace the Transport Motor (PL 23.13). Replace the Finisher PWB (PL 23.16). If the problem persists, replace the Transport Motor (PL 23.13). Check the Exit Roller, Paddle Shaft and Eject Belt for wear, damage or contamination (PL 23.13). Check the Compiler Exit Sensor and Transport Motor circuits for an intermittent condition. If the problem continues, replace the Finisher PWB (PL 23.16).

← Xem tất cả mã lỗi Xerox WorkCentre 5335

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie