Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 012-903 — Xerox WorkCentre 5335

Code: 012-903

Description: (Integrated Finisher) Paper Remains at Compiler Exit Sensor RAP • At Power On, the Compiler Exit Sensor detected paper. • While the Main Motor was operating at initialization at Power On, the Compiler Exit Sensor detected paper. • When the Cycle down operation at the end of a job was complete, the Compiler Exit Sensor was On.
Remedy: Check for paper remaining on the Compiler Exit Sensor and how it is installed. The sensor is properly installed with no paper left there. Y↓N→Remove the remaining paper and reinstall the sensor properly. Enter Component Control [012-150]. Actuate the Compiler Exit Sensor. The display changes. Y↓N→Check the connections of P/J8709 and P/J8728. P/J8709 and P/J8728 are securely connected. Y↓N→Connect P/J8709 and P/J8728. Check for an open or short circuit between P/J8709 and P/J8728. The wires between P/J8709 and P/J8728 are OK. Y↓N→Repair the open or short circuit. Measure the voltage between Finisher PWB P/J8709-3 (+) and GND (-). The voltage is approx.+5VDC. Y↓N→Go to Integrated Finisher Wirenets and check the +5VDC circuit. Measure the voltage between Finisher PWB P/J8709-2 (+) and GND (-). Actuate the Compiler Exit Sensor. The voltage changes. Y↓N→Replace the Compiler Exit Sensor (PL 22.5). Check the wires and connectors for an intermittent open or short circuit. If the problem continues, replace the Finisher PWB (PL 22.7). Check the wires and connectors for an intermittent open or short circuit. If the problem continues, replace the Finisher PWB (PL 22.7).

← Xem tất cả mã lỗi Xerox WorkCentre 5335

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie