Description: Tray 2 No Paper RAP Tray 2 is out of paper.
Remedy: Check the installation of the Tray 2 No Paper Sensor (PL 9.4) and the operation of the actuator. The Sensor is installed correctly and the actuator works. Y↓N→Reinstall the Sensor. Execute Component Control [072-101], Tray 2 No Paper Sensor. Manually activate the Tray 2 No Paper Sensor. The display changes. Y↓N→Go to BSD 7.6 - Tray 2 Paper Stacking. Troubleshoot the circuit of the Tray 2 No Paper Sensor (PL 9.5). Refer to the OF 99-2, Transmissive Sensor RAP. Go to the 072-210 RAP to check the Tray 2 Feed LIft Motor. • Disconnect then reconnect the ESS, MCU all PWBs connected to them (RAM, Firmware module, EEPROM) • Check the sw version of the controller sw - update if required (GP 16)