Description: Low Staples RAP (Finisher LX) Staples Near Empty or Staple-feed failure.
Remedy: Execute Component Control [012-242 Low Staple Sensor]. Install and remove the Staple Cartridge. The display changes. Y↓N→Check the Staple Cartridge for failure or foreign substances. There are no foreign substances and nothing has failed. Y↓N→Repair the failure and remove the foreign substances. Check the wires between J8886 and P/J8981 for a loose connection, or an open or a short circuit. The wires are OK. Y↓N→Repair as required. Measure the voltage between the Finisher PWB J8886-5 (+) and GND (-). The voltage is approx. +5VDC. Y↓N→Replace the Finisher PWB (PL 22.7). Measure the voltage between the Finisher PWB J8886-7 (+) and GND (-). Install and remove the Staple Cartridge. The voltage changes. Y↓N→Replace the Finisher PWB (PL 23.16). Replace the Staple Assembly (PL 23.4) If the problem persists, replace the Finisher PWB (PL 23.16). Check the sw version of the controller sw - update if required. Replace the Finisher PWB (PL 23.16).