Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 071-210 — Xerox WorkCentre 5335

Code: 071-210

Description: Tray 1 Lift Fail RAP Tray 1 Lift NG has occurred 3 times in a row.
Remedy: Remove Tray 1. Turn the power ON and enter the Diag mode. Turn ON Component Control [071-002] CCW [071-003] CW] (Tray 1 Feed/Lift Motor). Does the Tray 1 Feed/Lift Motor rotate? Y↓N→Check the connection between the MCU PWB P/J417 and the Tray 1 Feed/Lift Motor P/ J213 for open circuit, short circuit, and poor contact. Measure the resistance between the MCU PWB P/J417-5/6/7/8 and the Frame. Is the resistance infinite for all? Y↓N→Check the wires of the pins with non-infinite resistance for peeled-off coatings and short circuits due to pinching. Replace the Tray 1 Feed/Lift Motor (PL 9.6). Replace the MCU PWB (PL 18.2). Press the Stop button. Turn ON Component Control [071-102] (Tray 1 Level Sensor). Use a sheet of paper, etc. to block/clear the light path to the Tray 1 Level Sensor. Does the display change between High/Low? Y↓N→Use OF 99-2 RAP to check the Tray 1 Level Sensor (PL 9.5). Press the Stop button and turn the power OFF. Reload the machine software (GP 16). Check the Tray Lift Gear for damage or the Tray Lift mechanism for mechanical load. If no problems are found, replace the MCU PWB (PL 18.2).

← Xem tất cả mã lỗi Xerox WorkCentre 5335

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie