Description: Tray 2 Lift Fail RAP Tray 2 Lift NG has occurred 3 times in a row.
Remedy: Remove Tray 2. Turn the power ON and enter the Diag mode. Turn ON Component Control [072-002] CCW [072-003] CW] (Tray 1 Feed/Lift Motor). Does the Tray 2 Feed/Lift Motor rotate? Y↓N→Check the connection between the MCU PWB P/J410 and the Tray 1 Feed/Lift Motor P/ J216 for open circuit, short circuit, and poor contact. Measure the resistance between the MCU PWB P/J416-A1/A2/A3/A4 and the Frame. Is the resistance infinite for all? Y↓N→Check the wires of the pins with non-infinite resistance for peeled-off coatings and short circuits due to pinching. Replace the Tray 2 Feed/Lift Motor (PL 9.5). Replace the MCU PWB (PL 18.2). Press the Stop button. Turn ON Component Control [072-102] (Tray 2 Level Sensor). Use a sheet of paper, etc. to block/clear the light path to the Tray 1 Level Sensor. Does the display change between High/Low? Y↓N→Use OF 99-2 RAP to check the Tray 2 Level Sensor (PL 9.6). Press the Stop button and turn the power OFF. Reload the machine software (GP 16). Check the Tray Lift Gear for damage or the Tray Lift mechanism for mechanical load. If no problems are found, replace the MCU PWB (PL 18.2).