Code: 077-131
Description: Duplex Sensor On Jam RAP The Duplex Sensor does not turn ON within the specified time after the Exit 2 Motor has started rotating in the Duplex intake direction.
Remedy: Check the following: • A paper transportation failure due to a foreign substance/burr on the paper path • Each Duplex Roll and Pinch Roll for contamination, wear, and revolution failure • Each Exit Roll and Pinch Roll for contamination, wear, and revolution failure • Each Duplex Roll Drive Gear for wear and damage • Each Exit Roll Drive Gear for wear and damage • Use of paper out of spec • The Duplex Sensor for contamination, improper installation, and Actuator operation failure
Check the following: • The Duplex Sensor for failure: Component Control [077-105] (PL 14.4) • The connection between the Duplex Sensor P/J109 and the MCU PWB P/J409 for open circuit, short circuit, and poor contact • The Duplex Motor for failure: Component Control [077-070] (PL 14.4) • The Exit 2 Motor for revolution failure: Component Control [077-015] (PL 17.5) • The Exit Gate Solenoid for failure: Component Control [077-004] (PL 17.4) Reload the machine software (GP 16). If no problems are found, replace the MCU PWB (PL 18.2).
Check the following: • The Duplex Sensor for failure: Component Control [077-105] (PL 14.4) • The connection between the Duplex Sensor P/J109 and the MCU PWB P/J409 for open circuit, short circuit, and poor contact • The Duplex Motor for failure: Component Control [077-070] (PL 14.4) • The Exit 2 Motor for revolution failure: Component Control [077-015] (PL 17.5) • The Exit Gate Solenoid for failure: Component Control [077-004] (PL 17.4) Reload the machine software (GP 16). If no problems are found, replace the MCU PWB (PL 18.2).