Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 078-101 — Xerox WorkCentre 5335

Code: 078-101

Description: HCF to Feed Out Sensor Fault RAP The Tray 2 Feed Out Sensor did not come on within the specified time after the start of feed from Tray 6 (HCF).
Remedy: Clear the paper jam. Operate the printer from Tray 2. A 072-101 misfeed occurs. Y↓N→Press the Stop button. Turn ON Component Control [077-033] (TM Takeaway Motor). Does the TM Takeaway Motor rotate? Y↓N→Is the voltage between the TM Takeaway Motor P/J224-4/6 (+) and the GND (-) +24VDC? Y↓N→Go to +24VDC Power RAP. Turn the power OFF, disconnect the TM Takeaway Motor connector P/J224. Measure the TM Takeaway Motor wire wound resistance. • Between the TM Takeaway Motor P/J224-2 and P/J224-1 • Between the TM Takeaway Motor P/J224-2 and P/J224-3 • Between the TM Takeaway Motor P/J224-5 and P/J224-4 • Between the TM Takeaway Motor P/J224-5 and P/J224-6 Is the resistance approx. 0.85Ohm for each? (When the temperature is 25 °C) Y↓N→Replace the TM Takeaway Motor (PL 11.5) Measure the resistance between the disconnected TM Takeaway Motor connectors P/J224-1/3/4/6 and the Frame. Is the resistance infinite for all? Y↓N→Check the wires of the pins with non-infinite resistance for peeled-off coatings and short circuits due to pinching. Check the connection between the Tray Module PWB P/J554 and the TM Takeaway Motor P/J224 for open circuit, short circuit, and poor contact. If no problems are found, replace the following parts in sequence: • Tray Module PWB (PL 11.13) • MCU PWB (PL 18.2) Check the following: • Takeaway Rolls 1 and 2 and 3 for dirt/paper particles/wear/a poor rotation • HCF and IOT for a poor docking • HCF Transport Belt for poor tension • HCF Transport Roll for dirt/paper particles/wear/a poor rotation • HCF Takeaway Rolls 1-3 for dirt/ paper particles/wear/a poor rotation • HCF Exit Roll for dirt/ paper particles/wear/a poor rotation • Drive gears for wear/breakage • If the results of the above checks are OK, replace Tray Module PWB (PL 11.13). Go to 072-101 Tray 2 Misfeed RAP.

← Xem tất cả mã lỗi Xerox WorkCentre 5335

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie