Description: Tray 1 Misfeed RAP 08-101 The lead edge of the paper failed to actuate the tray 1 feed sensor within the correct time after feeding paper from tray 1.
Remedy: Do not manually lower the feed head, always use the paper tray to activate the feed head. Manually lowering the feed head will result in damage to the paper feed assembly. NOTE: The front door interlock must be cheated when checking +24V components. NOTE: To help fault diagnosis, install the tray 1 paper feed assembly in the tray 2 paper feed assembly position. With tray 1 removed, the operation of the feed assembly can be observed. Refer to. Enter dC330 code 08-101 tray 1 feed sensor, Q08-101.. Press Start. Open the left hand door and manually actuate the sensor. The display changes. Y↓N→Go to Flag 1. Check Q08-101. Refer to: • GP 11 How to Check a Sensor. • P/J276, Tray 1 and 2 control PWB. • 01E +5V Distribution RAP. • 01B 0V Distribution RAP. Install new components as necessary: • Tray 1 feed sensor, PL 7.30 Item 25. • Tray 1 and 2 control PWB, PL 7.10 Item 2. Enter dC330 code 08-025 tray 1 and 2 transport motor, MOT08-025. Press Start. The motor runs. Y↓N→Go to Flag 2. Check MOT08-025. Refer to: • GP 10 How to Check a Motor. • P/J273, Tray 1 and 2 control PWB. • 01G +24V Distribution RAP. • 01B 0V Distribution RAP. Install new components as necessary: • Tray 1 and 2 transport motor, PL 8.25 Item 5. • Tray 1 and 2 control PWB, PL 7.10 Item 2. The transport rolls rotate. Y↓N→Check the drive belt and gears, PL 8.25 Item 2. CAUTION To prevent damage to the feed mechanism, the paper tray must be pulled out before MOT 08- 010 is run in diagnostics. Enter dC330 code 08-010 tray 1 paper Feed motor, MOT08-010, Pull out the tray. Press Start. The motor runs. Y↓N→Go to Flag 3. Check MOT08-010. Refer to: • GP 10 How to Check a Motor. • P/J274, Tray 1 and 2 control PWB. • 01D +3.3V Distribution RAP. • 01G +24V Distribution RAP. • 01B 0V Distribution RAP. Instal new Components as necessary: • Tray 1 feed motor, PL 8.26 Item 6. • Tray 1 and 2 control PWB, PL 7.10 Item 2. Perform the following: • Clean the feed roll using a cloth dampened with water. • Check the feed roll assembly, PL 8.26 Item 3. • Check the feed assembly, PL 8.26 Item 1.