Description: Rear Tamper Move Failure RAP 11-007-120 Rear tamper fails to move to the front position. 11-008-120 Rear tamper fails to move to the rear position. 11-312-120 Rear tamper is not at the front home position. 11-313-120 Rear tamper is not at the rear home position. 11-319-120 Rear tamper is not at the away home position.
Remedy: NOTE: All 1K LCSS interlocks must be made to supply +24V to the motors. NOTE: In diagnostics, actuating any 1K LCSS sensor or switch can change the displayed state on the UI. Make sure that the correct sensor or switch is tested. Enter dC330, codes 11-004 and 11-006 alternately. The rear tamper moves between the home and inboard positions. Y↓N→Go to Flag 3. Check the rear tamper motor, MOT11-004. Refer to: • 11F-120 1K LCSS PWB Damage RAP. • GP 10, How to Check a Motor. • P/J9, 1K LCSS PWB. • 11C-120 1K LCSS Power Distribution RAP. Repair or install new components as necessary: • Tamper assembly, PL 11.112 Item 1. • 1K LCSS PWB, PL 11.124 Item 1. Enter dC330 code 11-311. Actuate the rear tamper home sensor Q11-311. The display changes. Y↓N→Go to Flag 1. Check Q11-311. Refer to: • 11F-120 1K LCSS PWB Damage RAP. • GP 11, How to Check a Sensor. • P/J16, 1K LCSS PWB • 11C-120 1K LCSS Power Distribution RAP. Repair or install new components as necessary: • Rear tamper home sensor, PL 11.112 Item 3. • 1K LCSS PWB, PL 11.124 Item 1. NOTE: The away home position is used for short edge feed small paper. This saves unnecessary rear tamper travel. Enter dC330. Actuate the rear tamper away home sensor Q11-319. The display changes. Y↓N→Go to Flag 2. Check Q11-319. Refer to: • 11F-120 1K LCSS PWB Damage RAP. • GP 11, How to Check a Sensor. • P/J16, 1K LCSS PWB • 11C-120 1K LCSS Power Distribution RAP. Repair or install new components as necessary: • Rear tamper away home sensor, PL 11.112 Item 3. • 1K LCSS PWB, PL 11.124 Item 1. Perform SCP 6 Final Actions.