Description: Sheet Not Exiting to Bin 1 RAP 11-140-170 The lead edge of a sheet is late arriving at the 2nd from top exit sensor. 11-142-170 The trail edge of a sheet is late leaving the 2nd from top exit sensor.
Remedy: Enter dC330, code 11-140. Actuate the 2nd from top exit sensor, Q11-140. The display changes. Y↓N→Go to Flag 1. Check the sensor Q11-140. Refer to: • GP 11, How to Check a Sensor. • P/J409, Carriage PWB. • 11C-170 HCSS BM Power Distribution RAP. Install new components as necessary: • Carriage PWB, PL 11.72 Item 5. • 2nd to top exit sensor, PL 11.73 Item 5. Enter dC330, code 11-023 to run the eject motor, MOT 11-020. The eject housing cycles between open and closed. Y↓N→Go to Flag 3. Check the motor. MOT 11-020 Refer to: • GP 10, How to Check a Motor. • P/J406, Carriage PWB. • 11C-170 HCSS BM Power Distribution RAP. Install new components as necessary: • Carriage PWB, PL 11.72 Item 5. • Eject motor, PL 11.73 Item 2. Enter dC330, code 11-010 to run the compiler carriage eject roll motor, MOT11-120. The motor runs. Y↓N→Go to Flag 2. Check the motor MOT 11-120. Refer to: • GP 10, How to Check a Motor. • P/J408, Carriage PWB. • 11C-170 HCSS BM Power Distribution RAP. Install new components as necessary: • Carriage PWB, PL 11.72 Item 5. • Eject roll motor, PL 11.75 Item 1. Check the condition of the eject motor drive belt, PL 11.75 Item 2. The drive belt is good. Y↓N→Install a new eject motor drive belt, PL 11.75 Item 2. Go to Flag 4, check the harness and connectors P/J412 and P/J432, refer to GP 7. The harness and connectors are good. Y↓N→Repair the harness, or install new parts as necessary. Perform SCP 6 Final Actions.