Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 07-353 — Xerox WorkCentre 5645

Code: 07-353

Description: Tray 1 Elevator Lift Failure RAP 07-353 Tray 1 stack height sensor did not actuate within the correct time after the feed / elevator motor turned on.
Remedy: Enter dC330 code 07-336 tray 1 stack height sensor, Q07-336. Press Start. Pull out tray 1 and push fully home. The display changes Y↓N→Go to Flag 1. Check Q07-383. Refer to: • GP 11 How to Check a Sensor. • P/J274, Tray 1 and 2 control PWB • 01E +5V Distribution RAP. • 01B 0V Distribution RAP. Install new components as necessary: • Tray 1 stack height sensor, PL 8.26 Item 7. • Tray 1 and 2 control PWB, PL 7.10 Item 2. CAUTION To prevent damage to the elevator and paper feed mechanism, the paper tray must be pulled out before MOT07-010 is run in diagnostics. Enter dC330 code 07-010 tray 1 feed / elevator motor, MOT07-010. Pull out tray 1. Press Start. The motor runs Y↓N→Go to Flag 2. Check MOT07-010. Refer to: • GP 10 How to Check a Motor. • P/J274, Tray 1 and 2 control PWB. • 01G +24V Distribution RAP. • 01B 0V Distribution RAP Install new components as necessary: • Tray 1 Feed / elevator motor, PL 8.26 Item 8. • Tray 1 and 2 control PWB, PL 7.10 Item 2. Perform the following: • Check the feeder / elevator motor drive gears. • Check the tray 1 stack height mechanism on the feeder assembly, If the fault still occurs then go to 07A Tray 1 and Tray 2 False Paper Level RAP.

← Xem tất cả mã lỗi Xerox WorkCentre 5645

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie