Description: Tray 2 Misfeed RAP 08-102 The lead edge of the paper failed to actuate the tray 2 feed sensor within the correct time after feeding paper from tray 2.
Remedy: Do not manually lower the feed head, always use the paper tray to activate the feed head. Manually lowering the feed head will damage the paper feed assembly. NOTE: The front door interlock must be cheated when checking +24V components. Enter dC330 code 08-102 tray 2 feed sensor, Q08-102.. Press Start. Open the left hand door and manually actuate the sensor. The display changes. Y↓N→Go to Flag 1.Check Q08-102. Refer to: • GP 11 How to Check a Sensor. • P/J276, Tray 1 and 2 control PWB. • 01E +5V Distribution RAP. • 01B 0V Distribution RAP. Install new components as necessary: • Tray 2 feed sensor, PL 7.30 Item 24. • Tray 1 and 2 control PWB, PL 7.10 Item 2. Enter dC330 code 08-025 tray 1 and 2 transport motor, MOT08-025. Press Start. The motor runs. Y↓N→Go to Flag 2. Check MOT08-025. Refer to: • GP 10 How to Check a Motor. • P/J273, Tray 1 and 2 control PWB. • 01G +24V Distribution RAP. • 01B 0V Distribution RAP. Install new components as necessary: • Tray 1 and 2 transport motor, PL 8.25 Item 5. • Tray 1 and 2 control PWB, PL 7.10 Item 2. The transport rolls rotate. Y↓N→Check the drive belt and gears, GP 7, PL 8.25 Item 2. CAUTION To prevent damage to the feed mechanism, the paper tray must be pulled out before MOT 08- 020 is run in diagnostics. Enter dC330 code 08-020 tray 2 paper feed motor, MOT08-020. Pull out the tray. Press Start. The motor runs. Y↓N→Go to Flag 3. Check MOT08-020. Refer to: • GP 10 How to Check a Motor. • P/J275, Tray 1 and 2 control PWB. • 01E +5V Distribution RAP. • 01G +24V Distribution RAP. • 01B 0V Distribution RAP. Instal new Components as necessary: • Tray 2 feed motor, PL 8.26 Item 6. • Tray 1 and 2 control PWB PL 7.10 Item 2. Perform the following: • Clean the feed roll using a cloth dampened with water. • Check the feed roll assembly, PL 8.26 Item 3. • Check the feed assembly, PL 8.26 Item 2.