Code: 03010000-200C
Description: Multi sensor error. When media was fed, the multi sensor could not detect the media width. When the right edge of media was detected, the multi sensor detected that the media had been loaded at a wrong position. When the leading edge of media was to be detected, the multi sensor could not detect the leading edge of media. When media was fed, the multi sensor detected media smaller than the specified size. When media was fed, the multi sensor detected media larger than the specified size. When media was fed, the multi sensor detected skew greater than the specified one. When media was fed, the multi sensor could not detect the right edge of media. When media was fed, the multi sensor could not detect the left edge of media.
Causes: Media, media loading method, paper path, multi sensor, carriage PCB, or main controller PCB
Remedy: 1. Media check If there is any print or stain in the detection area on the media or the media seze is not the specified one, replace the media. 2. Media loading position check If the media loading position is wrong, load the media again. 3. Visual check Remove foreign substances from multi sensor if any. 4. Multi sensor Select [SERVICE MODE]>[DISPLAY]>[SYSTEM]>[SIZE CR] to check the value read by the multi sensor. If the value is wrong, replace the multi sensor. 5. Cable continuity check If continuity of the cable between the head relay PCB and the carriage relay PCB is abnormal, replace the cable. 6. Replace the Carriage PCB 7. Cable continuity check If continuity of the cable beween the carriage PCB and the main controller PCB is abnormal, replace the cable. 8. Replace the main controller PCB.