Description: Registration Jam RAP (32-55 ppm) 08-150 The lead edge of the paper failed to actuate the registration sensor within the correct time after the paper was released from the wait point. 08-151 The trail edge of the paper was late to the registration sensor after the registration clutch, CL08-070 on.
Remedy: NOTE: Ensure that the front door interlock is cheated when checking +24V components. Enter dC330 code 08-150 registration sensor, Q08-150. Press Start. Open the left hand door and manually actuate the registration sensor. The display changes. Y↓N→Go to Flag 1. Check Q08-150. Refer to: • GP 11 How to check a Sensor. • P/J16, IOT PWB. • 01D +3.3V Distribution RAP. • 01B 0V Distribution RAP. Install new components as necessary: • Registration sensor, (32-55 ppm) PL 8.15 Item 3. • Perform OF7 IOT PWB Diagnostics RAP before a new IOT PWB is installed, PL 1.10 Item 2. Enter dC330 code 08-100 wait sensor, Q08-100. Press Start. Open the left hand door and manually actuate the wait sensor. The display changes. Y↓N→Go to Flag 2. Check Q08-100. Refer to: • GP 11 How to Check a Sensor. • P/J16, IOT PWB. • 01D +3.3V Distribution RAP. • 01B 0V Distribution RAP. Install new components as necessary: • Wait sensor, (32-55 ppm) PL 8.15 Item 3. • Perform OF7 IOT PWB Diagnostics RAP before a new IOT PWB is installed, PL 1.10 Item 2. Enter dC330 code 04-010 main drive motor. Press Start. The motor runs. Y↓N→Go to the 04A Main Drive Motor and Photoreceptor Motor RAP. While the motor is running, add code 08-070 registration clutch, CL08-070. Press Start. NOTE: The registration clutch will switch off after 5 seconds. Switch the registration clutch on / off up to 10 times. The jam clearance knob 4c, PL 8.15 Item 10, rotates when the registration clutch is energized. Y↓N→Go to Flag 3. Check CL08-070. Refer to: • GP 12 How to Check a Solenoid or Clutch. • P/J5, IOT PWB. • P/J17, LVPS. • Fuse, PL 1.10 Item 9, GP 7. • 01G +24V Distribution RAP. • 01B 0V Distribution RAP. Install new components as necessary: • Registration clutch, (32-55 ppm) PL 8.15 Item 7. • Perform OF7 IOT PWB Diagnostics RAP before a new IOT PWB is installed, PL 1.10 Item 2. Perform the following: • Check the registration transport rolls and registration rolls, (32-55 ppm) PL 8.15 Item 1, GP 7. • Check the drives plate on the registration clutch for damage and contamination. Refer to the replacement procedure. If necessary, install a new registration clutch, PL 8.15 Item 7. • Check the tray 1 and 2 transport motor, PL 8.25 Item 5. Ensure that the motor runs correctly. • Check the tray 1 and 2 transport roll assemblies, transport drive belt and pulleys, PL 8.25 Item 2, PL 8.25 Item 3, GP 7. Install new components as necessary. • Install a new tray 1 and 2 control PWB, PL 7.10 Item 2.