Description: Stapling Unit Movement Failure RAP 11-053-130 The stapling unit fails to move. 11-370-130 The stapling unit is not at the home position. NOTE: Movement failure can occur if the staple head jaws are not fully open and contact the compiler tray while indexing. NOTE: The home position is with the staple head at the corner stapling position (Fully to the front of the HCSS and rotated through 45 degrees).
Remedy: Enter dC330, code 11-053 (forward) and 11-054 (reverse) to check the movement of the stapling unit. The stapling unit moves as expected. Y↓N→Go to Flag 2. Check the stapling unit traverse motor, MOT11-053. Refer to: • GP 10 How to Check a Motor. • P/J413, Carriage PWB. • 11C-130 HCSS Power Distribution RAP. Install new components as necessary: • Carriage PWB, PL 11.46 Item 5. • Stapling unit traverse motor, PL 11.48 Item 14. Enter dC330, code 11-370, stapling unit 1 home sensor, Q11-370. Use a 5.5mm nut driver to rotate the stapler traverse shaft. Manually move the stapler away from, then back to, the home position. The display changes. Y↓N→Go to Flag 1. Check the sensor Q11-370. Refer to: • GP 11 How to Check a Sensor. • P/J409, Carriage PWB. • 11C-130 HCSS Power Distribution RAP. Install new components as necessary: • Carriage PWB, PL 11.46 Item 5. • Stapling unit 1 home sensor, PL 11.48 Item 15. Enter dC330, code 11-01, tray hold solenoid, SOL 11-011. The solenoid energises. Y↓N→Go to Flag 4. Check the solenoid SOL 11-001. Refer to: • GP 12 How to Check a Solenoid or Clutch. • P/J402, Carriage PWB. • 11C-130 HCSS Power Distribution RAP. Install new components as necessary: • Carriage PWB, PL 11.46 Item 5. • CC tray hold solenoid assembly, PL 11.49 Item 3. Go to Flag 3. Check the harness and connectors P/J412 and P/J432, refer to GP 7. The wiring and connectors are good. Y↓N→Repair the wiring or install new components as necessary. Perform SCP 6 Final Actions.