Description: HVF BM Compiler Exit Jam RAP 11-172-171 The trail edge is late leaving the BM compiler exit sensor.
Remedy: Lower the stapler bracket assembly. Enter dC330 code 11-190 BM paper present sensor, Q11-190. Actuate Q11-190. The display changes. Y↓N→Go to Flag 1. Check the sensor, Q11-190. Refer to: • GP 11, How to Check a Sensor. • P/J556, BM PWB. • 11A-171 HVF Power Distribution RAP. Install new components as necessary: • BM paper present sensor, PL 11.168 Item 5. • BM PWB, PL 11.166 Item 10. Go to Flag 1. Check the connectors and harness between PJ568 and P/J556. Refer to GP 7. The wiring and connectors are good. Y↓N→Repair the wiring or install new components as necessary. Enter dC330 code 11-060 BM compiler motor, MOT11-060. MOT11-060 runs. Y↓N→Go to Flag 2. Check MOT11-060. Refer to: • GP 10 How to Check a Motor. • P/J554, BM PWB. • 11A-171 HVF Power Distribution RAP. Install new components as necessary • BM compiler motor, PL 11.166 Item 1. • BM PWB, PL 11.166 Item 10. Unlatch the entrance baffle assembly, PL 11.80 Item 22. Run again MOT11-060. The BM entry roll rotates. Y↓N→Check the following components: • BM compiler motor belt, PL 11.166 Item 15. • BM entry roll pulley, PL 11.161 Item 14. • BM entry roll, PL 11.161 Item 15. Install new components as necessary. Make a 60 page booklet (15 sheets of paper). Check that the top sheet of paper has not been torn from the booklet. The booklet is good. Y↓N→Check that the components in the lower crease roll gear and clutch assembly are correctly installed. Refer to the replacement procedure-171 BM Crease Rolls, Gears and Bearings. Perform SCP 6 Final Actions.