Description: Scan Carriage Home Sensor RAP (65-87 ppm)
Remedy: shows the component location. Switch on the machine, GP 14. Observe the scan carriage assembly. The scan carriage assembly moves during the scan calibration process. Y↓N→Switch off the machine, GP 14. Remove the document glass, the CVT glass and the CVT ramp assembly. Check that the scan carriage is correctly attached to the scan cables, ADJ 14.2B Scan Carriage Assembly. NOTE: The scan motor cannot be driven is diagnostic mode. Go to Flag 3. Check the scan motor. Refer to: • GP 10 How to check a motor • 01G +24V Distribution RAP • 01E +5V Distribution RAP • 01B 0V Distribution RAP Repair or install new components as necessary: • Scanner drive belt, PL 14.16 Item 13. • Scan motor mount, PL 14.16 Item 2. • Scan motor, PL 14.16 Item 3. • Scanner PWB, PL 14.16 Item 8. • Scanner, PL 14.10 Item 1. Go to Flag 1. Check the voltages. As necessary, refer to: • 01D +3.3V Distribution RAP • 01F +12V Distribution RAP • 01G +24V Distribution RAP • 01B 0V Distribution RAP Check the wiring between P/J135 on the power distribution PWB in the image processing module and P/J455 and P/J450 on the scanner PWB. Repair as necessary or install a new power distribution PWB / scanner PWB harness, PL 14.16 Item 7. Perform the following: • Remove the DADH. • Remove the scanner top cover. • Reinstall the DADH. Switch on the machine. Enter dC330 code 14-100 carriage home sensor., pull out the scanner home sensor. Check that the sensor is clean. Actuate the sensor. The display changes. Y↓N→Go to Flag 2 and check Q14-100. Refer to: • GP 11 How to Check a Sensor. • P/J454, scanner PWB. • 01D +3.3V Distribution RAP. NOTE: The +5V supply for the sensor is generated on the scanner PWB from the +12V supply. If necessary, install a new scanner PWB, PL 14.16 Item 8. • 01B 0V Distribution RAP. • 01F +12V Distribution RAP Repair or install new components as necessary: • Scan carriage home sensor, PL 14.15 Item 7. • Sensor harness. • Scanner PWB, PL 14.16 Item 8. The sensor and scan motor are working correctly, the fault may be intermittent. Switch off the machine, GP 14. Remove the document glass, the CVT glass and the CVT ramp assembly. Check the following: • The connectors are correctly seated and the wiring is not damaged. • The scan carriage is mounted correctly, ADJ 14.2B Scan Carriage Assembly. • Check that the scanner drive belt is not loose, ADJ 14.3B Scan Motor.