Description: Fuser and Xerographic CRUM Communication Error RAP 03-371: The fuser CRUM communications have failed. 03-372: The xerographics CRUM communications have failed.
Remedy: Remove the fuser and xerographic modules to prevent damage to the CRUMs when checking for continuity. 1. Ensure the P/Js on the IOT PWB, PL 1.10 Item 2 and the main drive motor and PWB assembly, (32-55 ppm) PL 4.15 Item 6 or (65-87 ppm) PL 4.10 Item 6 are correctly and securely connected. 2. Perform OF7 IOT PWB Diagnostics RAP. 3. Switch off the machine, GP 14. Go to Flag 1. Disconnect P/J8 on the IOT PWB. Switch on the machine, GP 14. Make a copy. Check the fault history for new occurrences of 03- 371 and 03-372 faults. If new occurrences are not listed, install a new IOT PWB, PL 1.10 Item 2. 4. Go to Flag 1. Check the harness, GP 7 and measure the voltages. As necessary, refer to: • 01B 0V Distribution RAP. • 01E +5V Distribution RAP. NOTE: PJ141 and PJ144 are in-line connectors on the rear panel, (refer to Flag 2 and Flag 3). They are connected when the module is installed and are susceptible to damage. 5. 03-371 Only: Go to Flag 2. Check the harness. Repair as necessary. 6. 03-372 Only: Go to Flag 3. Check the harness. Repair as necessary. 7. Install new components as necessary: • 03-371 Only: Fuser connector assembly, (32-55 ppm) PL 4.15 Item 9 or (65-87 ppm) PL 4.10 Item 9. • 03-371 Only: Fuser Module, (32-55 ppm) PL 10.8 Item 1 or (65-87 ppm) PL 10.10 Item 1. • 03-372 Only: Xerographic module, (32-38 ppm) PL 9.22 Item 2 or (45-87 ppm) PL 9.20 Item 2. • Main drive motor PWB assembly, (32-55 ppm) PL 4.15 Item 6 or (65-87 ppm) PL 4.10 Item 6. • Main Drive Module, (32-55 ppm) PL 4.15 Item 1 or (65-87 ppm) PL 4.10 Item 1. 8. Reload the software, GP 4 Machine Software.