Remedy: Open the DADH top cover. Remove the DADH rear cover, PL 5.10 Item 1. Hold the top cover interlock switch closed. Enter dC330 code 05-330 to check the DADH feed sensor, Q05-330. Activate Q05-330. The display changes. Y↓N→Go to Flag 1. Check Q05-330. References: • GP 11 How to Check a Sensor. • P/J184 DADH PWB. • 01E +5V Distribution RAP. • The 5V return in the 01B 0V Distribution RAP. Install new components as necessary: • DADH feed sensor, PL 5.15 Item 2. • DADH PWB, PL 5.10 Item 5. Enter dC330 code 05-020 to run the DADH feed motor, MOT05-020. MOT05-020 runs. Y↓N→Go to the 05D DADH Motor Failure RAP. While MOT 05-020 runs, stack the code 05-025 to energize the DADH feed clutch, CL05-025. NOTE: The feed clutch disengages after 30 seconds. The feed motor stops after 3 minutes. CL05-025 energizes, the nudger rolls and the feed rolls rotate. Y↓N→Perform the steps that follow: • Go to the 05E DADH Feed Clutch Failure RAP and check CL05-025. • ADJ 5.1, DADH Drive Belt Adjustment. Enter dC330 code 05-010 to energize the DADH feed solenoid, SOL05-010. The feed roll assembly lowers, then raises after 10 seconds. Y↓N→Go to Flag 2. Check SOL05-010. References: • GP 12 How to Check a Solenoid or Clutch. • P/J183, DADH PWB and P/J201. • 01G +24V Distribution RAP. • The 24V return in the 01B 0V Distribution RAP. Install new components as necessary: • DADH feed solenoid, PL 5.15 Item 5. • DADH feed assembly, PL 5.15 Item 18. • DADH PWB, PL 5.10 Item 5. Perform the steps that follow: • Check that the DADH feed sensor, Q05-330 is installed correctly. If necessary, install a new feed roll assembly, PL 5.15 Item 1. • Ensure the feed motor drive belt and CVT motor drive belt are tensioned correctly, ADJ 5.1. • When large documents are fed (A3 or 11x17 inch), check the items that follow: – Check that the CVT motor rotates freely, refer to 05D DADH Motor Failure RAP – Check the CVT drive belt, refer to ADJ 5.1 DADH Drive Belt Adjustment. – Check that the CVT roll is clean and rotates freely, refer to ADJ 5.4. NOTE: If necessary install a new CVT motor, PL 5.25 Item 9. • Go to the 05E DADH Feed Clutch Failure RAP and check CL05-025. • Make sure that the size of the documents are sensed correctly. Refer to the 05C Document Size Sensor Failure RAP.