Description: Compiler Carriage Staple Head Unit Movement Failure RAP 11-053-170 The compiler carriage stapling unit fails to move. 11-370-170 The compiler carriage stapling unit is not at the home position.
Remedy: Enter dC330, codes 11-053 (forward) and 11-054 (reverse) to check the movement of the stapling unit. The stapling unit moves. Y↓N→Go to Flag 2. Check the stapling unit motor, MOT11-053. Refer to: • GP 10, How to Check a Motor. • P/J413, Carriage PWB. • 11C-170 HCSS BM Power Distribution RAP. Install new components as necessary: • Carriage PWB, PL 11.72 Item 5. • Stapling unit traverse motor, PL 11.74 Item 14. Enter dC330, code 11-370 to check the stapling unit 1 home sensor, Q11-370. Actuate the sensor by rotating the stapler traverse shaft using a 5.5mm nut driver. Manually move the stapler away from, then back to, the home position. The display changes. Y↓N→Go to Flag 1. Check the sensor Q11-370. Refer to: • GP 11, How to Check a Sensor. • P/J409, Carriage PWB. • 11C-170 HCSS BM Power Distribution RAP. Install new components as necessary: • Carriage PWB, PL 11.72 Item 5. • Stapling unit 1 home sensor, PL 11.74 Item 15. Go to Flag 4, Check the CC tray hold solenoid SOL 11-011. Refer to: • GP 12, How to Check a Solenoid or Clutch. • P/J402, Carriage PWB. • 11C-170 HCSS BM Power Distribution RAP. Install new components as necessary: • Carriage PWB, PL 11.72 Item 5. • CC tray hold solenoid assembly, PL 11.75 Item 3. Go to Flag 3, check the harness and connectors P/J412 and P/J432, refer to GP 7. The harness and connectors are good. Y↓N→Repair the wiring or install new components as necessary. Perform SCP 6 Final Actions.