Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 11-050-170, 11-360-170 — Xerox WorkCentre 5687F

Code: 11-050-170, 11-360-170

Description: Compiler Carriage Staple Head Operation Failure RAP 11-050-170 The compiler carriage staple head fails to cycle. 11-360-170 The compiler carriage staple head is not at the home position. NOTE: The home position is with the jaws of the staple head fully open. NOTE: Staple head operation faults can be caused by offline stapling failures. The user may be attempting to staple a set that exceeds the number of sheets/weight capacity. There may also be an offline stapling problem, refer to 11A-170 Offline Stapling RAP.
Remedy: NOTE: All HCSS BM interlocks must be made to supply +24V to the motors. Enter dC330, code 11-050 to cycle the staple head, then 11-051 to reverse the staple head to the home position. The staple head operates correctly. Y↓N→Go to Flag 1 and Flag 2, check the wiring and connectors between the HCSS PWB and the staple head. The wiring is good. Y↓N→Repair the wiring. Enter dC330, code 11-317, actuate the compiler carriage safety switch S11-317. The display changes. Y↓N→Go to Flag 3, Check the switch, S11-317. Refer to: • GP 13, How to Check a Switch. • P/J406, Carriage PWB. • 11D-110 HCSS BM Power Distribution RAP. • Ensure that the compiler carriage safety switch is correctly actuated by the switch actuator on the eject housing. Install new components as necessary: • Compiler carriage safety switch, PL 11.73 Item 4. • Staple head 1 unit, PL 11.72 Item 4. • Carriage PWB, PL 11.72 Item 5. Install a new staple head 1 unit, PL 11.72 Item 4. Enter dC330, code 11-051 (reverse) and code 11-050 (forward) to check the movement of the stapler head. The stapler head moves in increments along the carriage. The component start and stop buttons must be pressed several times to move the staple head to the end of the carriage. The staple head moves freely to the rear and returns to the front. Y↓N→Go to 11-053-170, 11-370-170 Compiler Carriage Stapler Head Unit Movement Failure RAP. Go to Flag 4, check the connectors and harness between P/J412 and P/J432, Refer to GP 7. The harness and connectors are good. Y↓N→Repair the wiring, or install new components as necessary.

← Xem tất cả mã lỗi Xerox WorkCentre 5687F

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie