Description: Compiler Ejector Movement Failure RAP 11-320-130 The compiler ejector is not at the home position. 11-322-130 The compiler ejector fails to complete a cycle of operation. NOTE: The home position for the compiler ejector is with the ejector closed. NOTE: A cycle of operation for the compiler ejector is to cycle between closed to open, then back to closed.
Remedy: Enter dC330, codes 11-023 to run the ejector motor. The ejector opens fully, then closes. Y↓N→Go to Flag 3. Check the ejector motor, MOT 11-020. Refer to: • GP 10, How to Check a Motor. • P/J406, Carriage PWB. • 11C-130 HCSS Power Distribution RAP. Install new components as necessary: • Carriage PWB, PL 11.46 Item 5. • Ejector motor assembly, PL 11.47 Item 2. Enter dC330, code 11-320, actuate the ejector home sensor, Q11-320. The display changes. Y↓N→Go to Flag 1 and Flag 4. Check the sensor. Refer to: • GP 11, How to Check a Sensor. • P/J409 and P/J411, Carriage PWB. • 11C-130 HCSS Power Distribution RAP. Install new components as necessary: • Carriage PWB, PL 11.46 Item 5. • Ejector home sensor, PL 11.47 Item 3. Enter dC330, code 11-317, actuate the compiler carriage safety switch, S11-317. The display changes. Y↓N→Go to Flag 2. Check the compiler carriage safety switch. Refer to: • GP 13 How to Check a Switch. • P/J406, Carriage PWB. • 11C-130 HCSS Power Distribution RAP. Install new components as necessary: • Carriage PWB, PL 11.46 Item 5. • Compiler Carriage safety switch, PL 11.47 Item 4. Go to Flag 5, check the harness and P/J412 and P/J432, refer to GP 7. The wiring and connectors are good. Y↓N→Repair the wiring or install new components. Perform SCP 6 Final Actions.