Description: Foreign Device PWB Fault RAP 03-412 The foreign interface device was not detected at power on.
Remedy: NOTE: Do not attach a foreign interface vend adaptor with this configuration of foreign interface PWB. Procedure Go to Flag 1. Check the harness. The harness is good. Y↓N→Perform the following as necessary: • Repair the harness. Refer to GP 7. • Install a new foreign interface harness, PL 3.22 Item 5. NOTE: Do not attempt to repair the harness from PJ124 to the foreign device. Check the +3.3V supply to P/J201 at pins 1, 5, 9, 16 and 22 on the single board controller PWB, The +3.3V supply is good. Y↓N→Go to: • 01D +3.3V Distribution RAP. • 01B 0V Distribution RAP. Disconnect the foreign device. Install a temporary shorting link between pins 2 and 3 on P/ J124. Check the voltage at PJ124 pin 2. 0V is measured. Y↓N→Install a new foreign interface PWB, PL 3.22 Item 4. If the fault remains, the foreign device is faulty. Disconnect the foreign device. Install a temporary shorting link between pins 1 and 3 on P/ J124. Check the display. Ensure the machine is now enabled to scan or print. The machine is enabled. Y↓N→Install new components as necessary: • Install a new foreign interface PWB, PL 3.22 Item 4. • Single board controller PWB, PL 3.24 Item 3. The enable circuits are working correctly. NOTE: Currently the signals used for billing, e.g. machine function, premium tray, etc. cannot be adequately measured with a standard meter.