Code: 03870001-2015
Description: Cut error. After roll media cutting, the multi sensor could not detect the media end.
Causes: Media, multi sensor, cutter unit, cutter lifter unit, cutter drive unit, cutter driver PCB, carriage PCB, or main controller PCB
Remedy: 1. Media check If there is any print or stain in the detection area on the media or the media size is not the specified one, replace the media. 2. Multi sensor Select [SERVICE MODE]>[DISPLAY]>[SYSTEM]>[SIZE CR] to check the value read by the multi sensor. If the value is wrong, replace the multi sensor. 3. Visual check Remove foreign substances from the multi sensor, the cutter unit, the cutter lifter unit, and the cutter drive unit if any. If the cutter unit, the cutter lifter unit, and the cutter drive unit is damaged or deformed, replace it. 4. Cable continuity check If continuity of the cable between the multi sensor and the carriage PCB is abnormal, replace the cable. 5. Cable continuity check If continuity of the cable between the cutter lifter unit, the cutter drive unit, and the cutter driver PCB is abnormal, replace the cable. 6. Replace the cutter driver PCB. 7. Replace the carriage PCB. 8. Replace the main controller PCB.