Description: Tray 3 or Tray 4 Paper Feed Jam RAP (W/O TAG 151) 08-108 The lead edge of the paper was late to tray 2 feed sensor when feeding from tray 3 or tray 4.
Remedy: NOTE: The front door interlock must be cheated when checking +24V components. Enter dC330 code 08-102 tray 2 feed sensor, Q08-102. Press Start. Manually actuate the sensor. The display changes. Y↓N→Go to Flag 1. Check Q08-102. Refer to: • GP 11 How to Check a Sensor. • P/J276, Tray 1 and 2 control PWB. • 01E +5V Distribution RAP. • 01B 0V Distribution RAP. Install new components as necessary: • Tray 2 feed sensor, PL 7.30 Item 24. • Tray 1 and 2 control PWB, PL 7.10 Item 2. Enter dC330 code 08-045 tray 3 and 4 transport motor, MOT08-045. Press Start. The motor runs. Y↓N→Go to Flag 2. Check MOT08-045. Refer to: • GP 10 How to Check a Motor. • P/J398, HCF control PWB. • 01G +24V Distribution RAP. • 01B 0V Distribution RAP. Install new components as necessary: • Tray 3 and 4 transport motor, PL 8.30 Item 7. • HCF control PWB, PL 7.20 Item 2. Y↓N→Check the gears and drive belt, PL 8.30 Item 8, PL 8.30 Item 9, GP 7. Perform the following: • Check the tray 3 and tray 4 transport rolls, PL 8.30 Item 18, GP 7. • If the fault occurs when feeding from tray 4. Go to RAP 08-104, 08-114 Tray 4 Misfeed RAP. • If the fault occurs when feeding from tray 3. Check the following, GP 7: – The takeaway roll assembly, PL 8.35 Item 2. – The transport roll assembly, PL 8.35 Item 11. – The transport roll bearing, PL 8.35 Item 3. – Go to RAP 08-103, 08-113 Tray 3 Misfeed RAP