Description: HVF BM Crease Roll Failure RAP 11-062-171 The HVF BM crease roll motor has failed to run.
Remedy: Release the crease roll nip pressure by moving the crease roll handle, PL 11.161 Item 5, fully counter clockwise. Remove the BM right hand cover, PL 11.168 Item 15, to access the crease rolls. Enter dC330 code 11-419. Actuate the BM crease roll motor encoder sensor by rotating the crease rolls slowly by hand. The display changes. Y↓N→Go to Flag 1. Check the BM crease roll motor encoder sensor, Q11-419. Refer to: • GP 11, How to Check a Sensor. • P/J552, BM PWB. • 11A-171 HVF Power Distribution RAP. Install new components as necessary: • BM PWB, PL 11.166 Item 10. • BM crease roll motor encoder sensor, PL 11.166 Item 9. Enter dC330, code 11-062 to run the BM crease roll motor, MOT 11-062. The motor runs. Y↓N→Go to Flag 2. Check the BM crease roll motor, MOT 11-062. Refer to: • GP 10 How to Check a Motor. • P/J557, BM PWB. • 11A-171 HVF Power Distribution RAP. Install new components as necessary: • BM crease roll motor, PL 11.166 Item 12. • BM PWB, PL 11.166 Item 10. The fault may be intermittent, check for damaged wiring or bad connectors. If necessary install new components: • BM crease roll motor encoder sensor, PL 11.166 Item 9. • BM crease roll motor, PL 11.166 Item 12. • BM PWB, PL 11.166 Item 10