Mã lỗi 11-450-171, 11-456-171 to 11-459-171 — Xerox WorkCentre 5745
Code:
11-450-171, 11-456-171 to 11-459-171
Description: HVF Ejector Module RAP 11-450-171 The ejector module motor has stalled 11-456-171 The ejector module did not return to the home position. 11-457-171 The ejector module did not move from the home position. 11-458-171 The ejector module did not return to the out position. 11-459-171 The ejector module did not move from the out position.
Remedy: shows the location of the components. Enter the dC330 code 11-320, ejector home sensor. Stack the dC330 code 11-053 to move the stapler unit inboard, and observe the display. This action moves the stapler unit inboard, and moves the ejector module to the out position. The display changes. Y↓N→The ejector module moved to the out position. Y↓N→Go to Flag 2. Check the wiring and repair as necessary. Check the ejector unit motor, MOT11-023. Refer to: • GP 10 How to Check a Motor. • P/J802, HVF Control PWB. • 11A-171 HVF Power Distribution RAP. Install new components as necessary: • Ejector assembly, PL 11.140 Item 2. • HVF control PWB, PL 11.157 Item 2. Go to Flag 1. Check the wiring and repair as necessary. Check the ejector home sensor, Q11-320. Refer to: • GP 11 How to Check a Sensor. • P/J401, HVF Control PWB. • 11A-171 HVF Power Distribution RAP. Install new components as necessary: • Ejector assembly, PL 11.140 Item 2. • HVF control PWB, PL 11.157 Item 2. Exit the diagnostics mode, selecting the Re-boot option. This returns the ejector module to the home position. Enter the dC330 code, 11-322, ejector unit out sensor. Stack the dC330 code, 11-053 to move the stapler unit inboard. The display changes. Y↓N→Go to Flag 3. Check the wiring and repair as necessary. Check the ejector unit out sensor, Q11-322. Refer to: • GP 11 How to Check a Sensor. • P/J401, HVF Control PWB. • 11A-171 HVF Power Distribution RAP. Install new components as necessary: • Ejector assembly, PL 11.140 Item 2. • HVF control PWB, PL 11.157 Item 2. Exit the diagnostics mode, selecting the Re-boot option. This returns the ejector module to the home position. Enter the dC330 code 11-177, ejector motor encoder. Stack the dC330 code, 11-053 to move the stapler unit inboard. The display changes condition for a few seconds. Y↓N→Go to Flag 4. Check the wiring and repair as necessary. Check the ejector motor encoder, Q11-177. Refer to: • GP 10 How to Check a Motor. • P/J401, HVF Control PWB. • 11A-171 HVF Power Distribution RAP. Install new components as necessary: • Ejector assembly, PL 11.140 Item 2. • HVF control PWB, PL 11.157 Item 2. Perform SCP 6 Final Actions.