Description: CCD PWB Not Detected RAP (W/O TAG 150) 14-310 The scanner PWB detects an abnormal power supply voltage or a CCD PWB failure.
Remedy: Go to Flag 1. Check the following voltages at P/J135 on the power distribution PWB: • +24V between pins 1 and 3. • +24V between pins 2 and 4. The voltages are good. Y↓N→Disconnect P/J135. Check the voltages again at P/J135 on the power distribution PWB. The voltages are good. Y↓N→Go to the following RAPs: • 01B 0V Distribution RAP, refer to the 24V return. • 01G +24V Distribution RAP. Check for a short circuit in the harness between P/J135 and P/J455. Repair the harness, or install a new harness, PL 14.25 Item 13. If the harness is good, install a new scanner PWB, PL 14.25 Item 4. Check that +24V is available in the scanner by entering the dC330 output code 14-005. The exposure lamp illuminates. Y↓N→Remove the CVT glass and document glass. Remove the PWB cover, 3 screws, PL 14.25 Item 1. Re-install the scanner top cover and GUI, but do not install the screws. Re-connect the power cord and switch on the machine, GP 14. Go to Flag 1. Check the following voltages at P/J455 on the scanner PWB: • +24V between pins 1 and 3. • +24V between pins 2 and 4. The voltages are good. Y↓N→Check for a open circuit on the harness between P/J135 and P/J455. Repair the harness, or install a new harness, PL 14.25 Item 13. Perform ADJ 14.1 Optics Cleaning Procedure. Go to the 14D Exposure Lamp Failure RAP. Go to Flag 2. Check the following voltages at P/J135 on the power distribution PWB: • +12V between pins 8 and 6. • +3.3V between pins 7 and 5. The voltages are good. Y↓N→Disconnect P/J135. Check the voltages again at the connector on the power distribution PWB. The voltages are good. Y↓N→Go to the relevant RAP: • 01B 0V Distribution RAP, refer to the 12V return and 3.3V return. • 01F +12V Distribution RAP. • 01D +3.3V Distribution RAP. Check for a short circuit on the harness between P/J135 and P/J450. Repair the harness, or install a new harness, PL 14.25 Item 13. Perform ADJ 14.1 Optics Cleaning Procedure. Go to Flag 2. Check the following voltages at P/J450 on the CCD PWB: • +12V between pins 1 and 2. • +3.3V between pins 3 and 4. The voltages are good. Y↓N→Check for an open circuit in the harness between P/J135 and P/J450. Repair the harness, or install a new harness, PL 14.25 Item 13. Perform ADJ 14.1 Optics Cleaning Procedure. Install new components in the following order: • CCD harness, PL 14.25 Item 5. • Scanner PWB, PL 14.25 Item 4. • Scanner, PL 14.20 Item 1.