Description: Scanning Document Size RAP (W/O TAG 150)
Remedy: Check that the input module angle sensor actuator is not damaged, if necessary, install a new input module angle sensor actuator, PL 14.25 Item 21. Enter the dC330 input code 14-310. Actuate the input module angle sensor, Q14-310 by opening and closing the DADH. The display changes. Y↓N→Go to Flag 2. Check for +12V on P/J135 between pins 6 and 8 on the power distribution PWB. The voltage is good. Y↓N→Go to the following RAPs: • 01B 0V Distribution RAP, refer to the 12V return. • 01F +12V Distribution RAP. Go to Flag 4. +5V is available at pin 3 on Q14-310 connector (yellow wire). Y↓N→Remove the CVT glass and document glass. Remove the PWB cover, 3 screws, PL 14.25 Item 1. Re-install the scanner top cover and GUI, but do not install the screws. Re-connect the power cord and switch on the machine, GP 14. Go to Flag 2. Check for +12V on P/J450 between pins 1 and 2 on the CCD PWB. The voltage is good. Y↓N→Check the harness between P/J135 and P/J450 for an open or short circuit. Repair the wiring, or install a new harness, PL 14.25 Item 13. Go to Flag 3. Check for +5V on P/J451 between pins 1 and 2 on the scanner PWB. The voltage is good. Y↓N→Install a new scanner, PL 14.20 Item 1. Go to Flag 3. Check for +5V on P/J452 between pins 17 and 18. The voltage is good. Y↓N→Check the connectors on the ribbon cable between P/J451 and P/J452 are correctly installed. If necessary install a new harness, PL 14.25 Item 5. +5V is available at P/J458 pins 1 and 4, also on P/J454 pin 4. Y↓N→Install a new scanner drive PWB, PL 14.25 Item 4. Check the wiring between P/J454 and Q14-310 for an open circuit. Go to Flag 4. Check the input module angle sensor, refer to: • P/J454, scanner PWB. • GP 11 How to Check a Sensor. • 01D +3.3V Distribution RAP. • 01B 0V Distribution RAP, refer to the 3.3V return. Repair or install new components as necessary: • Input module angle sensor, PL 14.25 Item 16. • Scanner PWB, PL 14.25 Item 4. • Scanner, PL 14.20 Item 1. Raise the DADH. Enter the dC330 input code 14-315. Actuate the document size sensor 1 by placing a piece of paper on the document glass above the sensor. Enter the dC330 input code 14-320 and repeat the test for document size sensor 2. The display changes for both sensors. Y↓N→Go to Flag 1. Check the document size sensors 1 and 2, refer to: • GP 11 How to Check a Sensor. NOTE: If necessary, temporarily install the document glass when checking the size sensors, to ensure that the document is the correct distance from the sensor. • 01D +3.3V Distribution RAP. • 01B 0V Distribution RAP, refer to the 3.3V return. Repair or install new components as necessary: • Document size sensor, PL 14.25 Item 3. • Scanner PWB, PL 14.25 Item 4. • Scanner, PL 14.20 Item 1. The scanner is working correctly, perform dC604 Registration Setup.