Description: HVF Entry Sensor RAP 11-100-171 The paper leading edge is late arriving at the entry sensor. 11-101-171 The paper trailing edge is late leaving the entry sensor.
Remedy: shows the location of the components. Enter dC330, code 11-100. Manually operate the entry sensor, Q11-100. The display changes. Y↓N→Go to Flag 1. Check the sensor, Q11-100. Refer to: • GP 11 How to Check a Sensor. • P/J101, HVF Control PWB • 11A-171 HVF Power Distribution RAP Install new components as necessary: • Entry sensor, PL 11.156 Item 2. • HVF Control PWB, PL 11.157 Item 2. Enter dC330, code 11-000 to run the Entry feed motor 1, MOT 11-000. The motor runs. Y↓N→Go to Flag 2. Check the entry feed motor 1, MOT 11-000. Refer to: • GP 10 How to Check a Motor. • P/J102, HVF Control PWB • 11A-171 HVF Power Distribution RAP Install new components as necessary: • Entry feed motor 1, PL 11.150 Item 2. • HVF control PWB, PL 11.157 Item 2. Check the drive belt on the motor. The drive belt is good. Y↓N→Install a new drive belt, PL 11.150 Item 7. The fault may be intermittent, check for damaged wiring or bad connectors. If necessary install new components: • Entry sensor, PL 11.156 Item 2. • Entry feed motor 1, PL 11.150 Item 2. • HVF control PWB, PL 11.157 Item 2. • Check if the HVF module has the W/TAG V-006 modifications installed. If the modifications have not been installed perform ADJ 11.13-171 HVF Performance Improvements W/ TAG V-006.