Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 11J-110 — Xerox WorkCentre 5765

Code: 11J-110

Description: Mis-Registration in Stapled Sets and Non-Stapled Sets RAP Use this RAP to identify and correct the causes of mis-registration in stapled sets, resulting in staples missing some sheets in the set, or poorly registered non-stapled sets.
Remedy: The most likely cause of mis-registration is paper condition and/or damage such as curl, wrinkle, creases, dog ears, etc. Curl, wrinkle and creases are probably caused in the IOT, go to IQ1 Image Quality Entry RAP. For other copy/print damage and dog ears, go to the 11H-110 Copy Damage in the 2K LCSS RAP. Check the following: • Check that bin 1 is seated correctly and the bin 1 alignment clip is in position, PL 11.2 Item 13. • Turn over the paper stack in the tray in use. • Use a new ream of paper in the tray in use. • Paper type especially recycled paper can lead to registration problems. Try changing to a different brand or type of paper. • Ensure that the guides in the paper trays are correctly set and reported on the UI for the paper size loaded. • Check that paper type is set correctly. If heavyweight paper is used but not set in the UI, the compiler capacity can be exceeded. • Check for obstructions in the compiler. • Ensure that the paddle roll operates correctly and that the paddles are not damaged. The paddles should park completely inside the top section of the compiler, with the shorter paddle in a vertical position. If all of the paddles are out of position, check the paddle roll position sensor, PL 11.8 Item 11, the flag, PL 11.8 Item 7 and the paddle motor assembly, PL 11.8 Item 10. If only one paddle is mis-aligned with the others, it can be re-positioned by hand (they are not bonded to the shaft). • Make sure the paddles are clean. If necessary, use formula A cleaning fluid, PL 26.10 Item 2 to clean the paddles. • Ensure that the tampers operate correctly, i.e. are not stalling or losing position during the job. Inspect the tampers for damage, if necessary install new parts. PL 11.16. • Inspect the bin 1 entry nips for roll damage. The idlers should be held against the rubber driving rolls and they should be free to rotate within their support springs. If necessary, install new parts, PL 11.23. • Inspect the four spring loaded guides on the output cover, PL 11.2 Item 7. Ensure that they are correctly located and are free to move up and down.

← Xem tất cả mã lỗi Xerox WorkCentre 5765

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie