Description: Tray 3 Paper Feed Jam RAP (W/TAG 151) 08-132 The lead edge of the paper was late to the HCF exit sensor when feeding from tray 3.
Remedy: NOTE: The front door interlock must be cheated when checking +24V components. Enter dC330 code 08-108 HCF exit sensor, Q08-104. Press Start. Manually actuate the HCF exit sensor. The display changes. Y↓N→Go to Flag 1. Check Q08-108. Refer to: • GP 11 How to Check a Sensor. • P/J3, HCF control PWB. • 01E +5V Distribution RAP. • 01B 0V Distribution RAP. Install new components as necessary: • HCF exit sensor, PL 8.33 Item 3. • HCF control PWB, PL 7.21 Item 2. Enter dC330 code 08-045 HCF transport motor, MOT08-045. Press Start. The motor runs. Y↓N→Go to Flag 2. Check MOT08-045. Refer to: • GP 10 How to Check a Motor. • P/J6, HCF control PWB. • 01G +24V Distribution RAP. • 01B 0V Distribution RAP. Install new components as necessary: • HCF transport motor, PL 8.32 Item 10. • HCF control PWB, PL 7.21 Item 2. The transport rolls rotate. Y↓N→Check the following: •, drive belt, PL 8.36 Item 6. •, drive coupling, PL 8.36 Item 7. •, idler roll assembly, PL 8.36 Item 8. • Tray 3 and 4 transport roll, PL 8.32 Item 4 Perform the 08-103, 08-113 Tray 3 Misfeed RAP.