Description: Paddle Roll Failure RAP 11-024-120 The paddle is not at the home position. 11-025-120 The paddle fails to rotate. NOTE: The home position of the paddle is when the sensor flag is located between the sensor jaws. Jams will occur in the compiler and bin 1 cannot be used.
Remedy: NOTE: All 1K LCSS interlocks must be made to supply +24V to the motors. NOTE: In diagnostics, actuating any 1K LCSS sensor or switch can change the displayed state on the UI. Make sure that the correct sensor or switch is tested. Enter dC330, codes 11-024, paddle home position and 11-025, paddle run. The paddle rotates correctly. Y↓N→Go to Flag 2. Check the paddle motor, MOT 11-024. Refer to: • 11F-120 1K LCSS PWB Damage RAP. • GP 10, How to Check a Motor. •. • P/J14, 1K LCSS PWB. • 11C-120 1K LCSS Power Distribution RAP Repair or install new components as necessary: • Paddle motor, PL 11.104 Item 10. • 1K LCSS PWB, PL 11.124 Item 1. Enter dC330, code 11-025 and stack the code 11-326, to actuate the paddle roll position sensor Q11-326. The display cycles high/low. Y↓N→Go to Flag 1. Check Q11-326. Refer to: • 11F-120 1K LCSS PWB Damage RAP. • GP 11, How to Check a Sensor. •. • P/J2, 1K LCSS PWB • 11C-120 1K LCSS Power Distribution RAP Repair or install new components as necessary: • Paddle roll position sensor, PL 11.104 Item 11. • 1K LCSS PWB, PL 11.124 Item 1. Perform SCP 6 Final Actions.