Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 14-730 — Xerox WorkCentre 5775

Code: 14-730

Description: Scanner Application Card Failure RAP 14-730 There is no response or an incorrect response to the command issued by the scan service.
Remedy: Perform the following: 1. Switch off the machine, then switch on the machine, GP 14. 2. Check that the harness from PJ152 is not routed under the single board controller PWB. If the harness was under the PWB, examine the harness sleeving for punctures or other damage. If necessary, install a new DADH/power distribution PWB harness, PL 3.24 Item 6. Route the new harness to the right, away from the single board controller PWB. If this has caused a blown fuse F1 on the power distribution PWB, install a new power distribution PWB, PL 3.24 Item 5. NOTE: This fault has been caused on a number of machines by bad routing of the DADH/ power distribution PWB harness PL 3.24 Item 6.

← Xem tất cả mã lỗi Xerox WorkCentre 5775

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie