Description: Front Door Open RAP 01-300 The front door has opened during machine operation.
Remedy: Enter dC330, code 01-300 front door interlock. Press start, open and close the front door. The display changes. Y↓N→Go to Flag 2. +12V is available at P/J147 pin 4 on the main drive PWB. Y↓N→Go to Flag 2. +12V is available at P/J147 pin 3 on the main drive PWB. Y↓N→Go to Flag 2. +12V is available at P/J16 pin 3 on the LVPS. Y↓N→Go to the 01F +12V Distribution RAP. Repair the wiring or the connector pins between P/J16 and P/J147. Remove the main drive module, (35-55 ppm) or (65-90 ppm). Go to Flag 2. Check the continuity to the xerographic module CRUM at P/J147, between pins 3 and 4. If necessary, check and repair the wiring between the main drive module and the xerographic CRUM. Go to Flag 1. +12V is available at P/J17, pin 5. Y↓N→Install a new LVPS and base module, PL 1.10 Item 3. Go to Flag 1. +12V is available at P/J17, pin 6. Y↓N→Check S01-300 and associated wiring. Refer to: • GP 13 How to Check a Switch. • P/J17 LVPS and base module. • Wiring Harness Repairs. If necessary, install a new door interlock switch, PL 1.10 Item 7. Go to Flag 3. Open the front door, then measure the signal at P/J26 pin 8 on the IOT PWB. +3.3V is measured. Y↓N→Install a new LVPS and base module, PL 1.10 Item 3. Perform OF7 IOT PWB Diagnostics RAP. If the fault remains, install a new IOT PWB, PL 1.10 Item 2. Check that the front door, PL 8.10 Item 10 closes correctly. If not, check the following: • The jam clearance latch, PL 8.20 Item 5. • (35 ppm) the xerographic module latch, PL 9.22 Item 7. • (40-90 ppm) the xerographic module latch, PL 9.20 Item 7. • (35-55 ppm) the fuser latch, PL 10.8 Item 5. • (65-90 ppm) the fuser latch, PL 10.10 Item 5. • The post fuser jam clearance latch, PL 10.15 Item 11. • The latch cam handle, PL 10.15 Item 14.