Description: LVF BM Hole Punch Operation Failure RAP 311-043-00-150 The hole punch fails to perform a punch cycle. 311-046-00-150 The hole punch is not at the home position.
Remedy: Go to Flag 5. Check the link between P/J307 pins 10 and 11, LVF PWB. The link is good. Y↓N→Repair the wiring or connector. Enter dC330, code 011-351, actuate the punch head present sensor, Q11-351. The display changes. Y↓N→Go to Flag 2. Check Q11-351. Refer to: • GP 11 How to Check a Sensor. • P/J307, LVF PWB. • 311D-150 LVF BM Power Distribution RAP. Repair or install new components as necessary: • Punch head home sensor, PL 11.54 Item 1. • LVF PWB, PL 11.90 Item 8. Enter dC330 code 011-350, actuate the punch head home sensor, Q11-350. The display changes. Y↓N→Go to Flag 1. Check Q11-350. Refer to: • GP 11 How to Check a Sensor. • P/J307, LVF PWB. • 311D-150 LVF BM Power Distribution RAP. Repair or install new components as necessary: • Punch head home sensor, PL 11.54 Item 1. • LVF PWB, PL 11.90 Item 8. Enter dC330 code 011-043, hole punch motor MOT11-042. The punch cycles. Y↓N→Go to Flag 3. Check MOT11-042. Refer to: • GP 10, How to Check a Motor. • P/J311, LVF PWB. • 311D-150 LVF BM Power Distribution RAP. Repair or install new components as necessary: • Hole punch motor assembly, PL 11.54 Item 2. • LVF PWB, PL 11.90 Item 8. NOTE: The chad bin collects the pieces of paper cut out by the hole punch. The chad bin level sensor will not operate if the bin is incorrectly installed. Ensure the chad bin is fully inserted and the lever engages in the slot. Enter dC330, code 011-348 chad bin level sensor, Q11-348. Use a strip of paper actuate Q11-348. The display changes. Y↓N→Go to Flag 4. Check Q11-340. Refer to: • GP 11 How to Check a Sensor. • P/J307, LVF PWB. • 311D-150 LVF BM Power Distribution RAP. Install new components as follows. • Chad bin full sensor, PL 11.54 Item 7. • LVF PWB, PL 11.90 Item 8. Perform SCP 5 Final Actions.