Description: HVF BM Staple Head 2 and Stapler Module RAP 311-403-00-171 The HVF BM staple head 2 motor has failed to move. 311-413-00-171 The HVF BM staple head 2 is not detected in the home position. 311-414-00-171 The booklet maker stapler module is not detected in the home (staple head closed) position during hard / soft initialize, or at set boundary.
Remedy: Enter dC330 code 011-421 to check the BM staple head carrier closed sensor, Q11-421. Open and close the staple head carrier. The display changes. Y↓N→Go to Flag 1. Check Q11-421. Refer to: • GP 11, How to Check a Sensor. • P/J552, BM PWB. • 311A-171 HVF Power Distribution RAP. Install new components as necessary: • BM staple head carrier closed sensor, PL 11.168 Item 18. • BM PWB, PL 11.166 Item 10. Remove the HVF front door and door support, refer to-171 HVF Covers. Pull out the BM module. Remove the staple head 2 cover, PL 11.168 Item 14. Enter dC330 code 011-413 to check the BM SH2 home switch, S11-413. Manually rotate the staple head to actuate the BM SH2 home switch. The display changes. Y↓N→Go to Flag 2. Check S11-413. Refer to: • GP 13, How to Check a Switch. • P/J551, BM PWB. • 311A-171 HVF Power Distribution RAP. Install new components as necessary: • BM staple head 2, PL 11.168 Item 7. • BM PWB, PL 11.166 Item 10. Enter dC330 code 011-403 to run the BM SH2 motor. The staple head cycled. Y↓N→Go to Flag 3. Check the wiring and connectors between P/J560 and P/J586. The wiring and connectors are good. Y↓N→Repair the wiring or connectors. Install a new BM staple head 2, PL 11.168 Item 7. The fault may be intermittent, check for damaged wiring or bad connectors. If necessary install new components: • BM staple head carrier closed sensor, PL 11.168 Item 18. • BM staple head 2, PL 11.168 Item 7. • BM PWB, PL 11.166 Item 10.