Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 311E-171 — Xerox WorkCentre 5855

Code: 311E-171

Description: Copy Damage in the HVF BM RAP Use this RAP to identify and correct the causes of copy damage in the HVF BM.
Remedy: Check the following: • Check the alignment between the IOT and the HVF BM, ADJ 11.1-171. • Look for paper fragments in the HVF BM paper path. Paper fragments can move through the IOT and HVF BM paper path without causing a problem until they finally wedge themselves at some point. A likely place for a fragment of paper to be wedged is at the hole punch assembly, where the top and bottom guides form the narrowest part of the paper path. • Ensure that the exit diverter gate solenoid, PL 11.150 Item 4, operates correctly and has it’s full movement. • Ensure that the hole punches park at the fully open position. If they protrude, even slightly, a jam will occur in the narrow paper path of the hole punch. Refer to the 311-044- 00-171 to 311-047-00-171 Punch Head Position RAP. • Check that all the idler rolls in the HVF BM paper path are free to rotate, particularly those on the jam clearance guides. Refer to ADJ 40.1 Machine Lubrication. • Make sure that the jam clearance guides 5a, 5b and 5c close and latch correctly. • Check that the paper path ribs of the jam clearance guide 5b, PL 11.161 Item 7 and the exit path PL 11.168 are free of scores and nicks. Check also for contamination and glue from label stock. • Make sure that the compiler carriage tampers move to the correct paper size. • Check that the paper size reported on the user interface corresponds to the actual paper size loaded in the trays, refer to the 371B Tray 1 and 2 Wrong Size Paper RAP. • Make sure that the BM tampers move to the correct paper size, refer to the 311-066-00- 171, 311-384-00-171 HVF BM Tamper Failure RAP. • Ensure that the BM paper guide, PL 11.161 Item 7, closes and latches correctly. • If the top sheet of paper is being been torn from booklets, check that the components in the lower crease roll gear and clutch assembly are correctly installed. Refer to the replacement procedure-171 BM Crease Rolls, Gears and Bearings. • If heavy-weight paper is used, the paper can stop in the vertical transport and cause a 10- 126 fault. The fault is caused when the vertical transport motor is over loaded. Check the position of the jam clearance guides 5a, 5b and 5c. Check the vertical transport rolls and bearings for contamination. If necessary remove and clean the drive shaft and the bearings. If the problem continues then install a new transport motor,.

← Xem tất cả mã lỗi Xerox WorkCentre 5855

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie