Description: Fuser and Xerographic CRUM Communication Error RAP 341-371-00 The fuser CRUM communications have failed. 341-372-00 The xerographics CRUM communications have failed.
Remedy: 1. Ensure the P/Js on the IOT PWB, PL 1.10 Item 2 and the main drive motor and PWB assembly, (45-55 ppm) PL 40.15 Item 6 or (65-90 ppm) PL 40.10 Item 6 are correctly and securely connected. 2. Perform the OF7 IOT PWB Diagnostics RAP. 3. Switch off the machine, GP 14. Go to Flag 1. Disconnect P/J8 on the IOT PWB. Switch on the machine, GP 14. Make a copy. Check the fault history for new occurrences of 41- 371-00 and 41-372-00 faults. If new occurrences are not listed, install a new IOT PWB, PL 1.10 Item 2. 4. Go to Flag 1. Check the harness, GP 7 and measure the voltages. As necessary, refer to: • 301B 0V Distribution RAP. • 301E +5V Distribution RAP. NOTE: PJ141 and PJ144 are in-line connectors on the rear panel, (refer to Flag 2 and Flag 3). They are connected when the module is installed and are susceptible to damage. 5. 41-371-00 Only: Go to Flag 2. Check the harness. Remove any torn paper/debris from the fuser CRUM connector, (45-55 ppm) PL 40.17 Item 12 or (65-90 ppm) PL 40.12 Item 12. Repair as necessary. 6. 41-372-00 Only: Go to Flag 3. Check the harness. Remove any torn paper/debris from the xerographic CRUM connector, (45-55 ppm) PL 40.17 Item 4 or (65-90 ppm) PL 40.12 Item 4. Repair as necessary. 7. Install new components as necessary: • 41-371-00 Only: Fuser connector assembly, (45-55 ppm) PL 40.15 Item 9 or (65-90 ppm) PL 40.10 Item 9. • 41-371-00 Only: Fuser Module, (45-55 ppm) PL 10.8 Item 1 or (65-90 ppm) PL 10.10 Item 1. • 41-372-00 Only: Xerographic module, PL 90.20 Item 2. • Main drive motor PWB assembly, (45-55 ppm) PL 40.15 Item 6 or (65-90 ppm) PL 40.10 Item 6. • Main drive module, (45-55 ppm) PL 40.15 Item 1 or (65-90 ppm) PL 40.10 Item 1. 8. Reload the software, GP 4 Machine Software.