Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 372-100-00 — Xerox WorkCentre 5855

Code: 372-100-00

Description: Tray 2 Elevator Lift Failure RAP 372-100-00 Tray 2 stack height sensor did not actuate within the correct time after the feed/elevator motor turned on.
Remedy: Enter dC330 code 072-330 tray 2 stack height sensor, Q72-330. Press Start. Pull out tray 2, then push fully home. The display changes. Y↓N→Go to Flag 1. Check Q72-330. Refer to: • GP 11 How to Check a Sensor. • P/J275, Tray 1 and 2 control PWB. • 301E +5V Distribution RAP. • 301B 0V Distribution RAP. Install new components as necessary: • Tray 2 stack height sensor, PL 80.26 Item 8. • Tray 1 and 2 control PWB, PL 70.10 Item 2. CAUTION To prevent damage to the elevator and paper feed mechanism, the paper tray must be pulled out before MOT72-010 is run in service mode. Enter dC330 code 072-010 tray 2 elevator motor, MOT72-010. Pull out tray 2. Press Start. The motor runs. Y↓N→Go to Flag 2. Check MOT72-010. Refer to: • GP 10 How to Check a Motor. • P/J275, Tray 1 and 2 control PWB. • 301G +24V Distribution RAP. • 301B 0V Distribution RAP Install new components as necessary: • Tray 2 elevator motor, PL 80.26 Item 6. • Tray 1 and 2 control PWB, PL 70.10 Item 2. Perform the following: • Check the elevator motor drive gears. • Check the tray 2 stack height mechanism on the feeder assembly, If the fault remains, go to the 371A Tray 1 and Tray 2 Empty RAP.

← Xem tất cả mã lỗi Xerox WorkCentre 5855

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie