Remedy: NOTE: Ensure that the front door interlock is cheated when checking +24V components. Enter dC330 code 082-150 registration sensor, Q82-150. Press Start. Open the bypass tray and left door assembly. Manually actuate Q82-150. The display changes. Y↓N→Go to Flag 1. Check Q82-150. Refer to: • GP 11 How to check a Sensor. • P/J5, IOT PWB. • 301D +3.3V Distribution RAP. • 301B 0V Distribution RAP. If necessary install a new registration sensor, (45-55 ppm) PL 80.15 Item 3. If the problem persists, perform OF7 IOT PWB Diagnostics RAP. Enter dC330 code 081-100 wait sensor, Q81-100. Press Start. Open the bypass tray and left door assembly. Manually actuate Q81-100 The display changes. Y↓N→Go to Flag 2. Check Q81-100. Refer to: • GP 11 How to Check a Sensor. • P/J5, IOT PWB. • 301D +3.3V Distribution RAP. • 301B 0V Distribution RAP. If necessary install a new wait sensor, (45-55 ppm) PL 80.15 Item 3. If the problem persists, perform OF7 IOT PWB Diagnostics RAP. Enter dC330 code 042-010 main drive motor, MOT42-010. Press Start. The motor runs. Y↓N→Go to the 340A Main Drive Motor and Photoreceptor Motor RAP. While the motor is running, add code 082-070 registration clutch, CL82-070. Press Start. NOTE: The registration clutch will de-energize after 5 seconds. Energize the registration clutch up to 10 times. The jam clearance knob 4c, PL 80.15 Item 10, rotates when the registration clutch is energized. Y↓N→Go to Flag 3. Check CL82-070. Refer to: • GP 12 How to Check a Solenoid or Clutch. • P/J5, IOT PWB. • P/J17, LVPS. • Fuse, PL 1.10 Item 9, GP 7. • 301G +24V Distribution RAP. • 301B 0V Distribution RAP. If necessary install a new registration clutch, (45-55 ppm) PL 80.15 Item 7. If the problem persists, perform OF7 IOT PWB Diagnostics RAP. Perform the following: • Refer to GP 7. Check the registration transport rolls and registration rolls, (45-55 ppm) PL 80.15 Item 1. • Check the drives plate on the registration clutch for damage and contamination. Refer to the replacement procedure. If necessary, install a new registration clutch, PL 80.15 Item 7. • Check the tray 1 and 2 transport motor, PL 80.25 Item 5. Ensure that the motor runs correctly. • Refer to GP 7. Check the tray 1 and 2 transport roll assemblies, transport drive belt and pulleys, PL 80.25 Item 2 and PL 80.25 Item 3. Install new components as necessary. • Install a new tray 1 and 2 control PWB, PL 70.10 Item 2. • Refer to. Make sure PJ44 is securely connected. • Check the fuser drive gear, PL 40.17 Item 10 for wear. If necessary, install a new fuser drive gear.