Description: Bypass Tray Registration Jam RAP (45-55 ppm) Initial Actions WARNING Ensure that the electricity to the machine is switched off while performing tasks that do not need electricity. Refer to GP 14. Disconnect the power cord. Electricity can cause death or injury. Moving parts can cause injury. • Make sure that the correct RAP is used. To identify the correct RAP to use, go to the 381- 155-00, 381-156-00 Bypass Tray Registration Jam Entry RAP. • Check the condition of the paper in the bypass tray. Refer to IQ1 and GP 20. • Check for obstructions in the paper path. • Check that the bypass tray and left door assembly is latched correctly. • Check that the interlock cover has not come loose, PL 70.30 Item 23. Bias the cover to the right and tighten the two screws • Check that the short paper path assembly latches without excessive force, PL 10.25 Item 1. . In replacement step 5, check the latch mechanism. • If the fault is 81-155-00, check the bypass tray empty actuator, refer to the 375A RAP.
Remedy: NOTE: The front door interlock must be cheated when checking +24V components. Enter dC330 code 082-150 registration sensor, Q82-150. Press Start.. Manually actuate Q82-150. The display changes. Y↓N→Go to Flag 1. Check Q82-150. Refer to: • GP 11 How to Check a Sensor. • P/J5, IOT PWB. • 301D +3.3V Distribution RAP. • 301B 0V Distribution RAP. If necessary install a new registration sensor, PL 80.15 Item 3. If the problem persists, perform OF7 IOT PWB Diagnostics RAP. Enter dC330 code 042-010 main motor, MOT42-010. Add code 082-070 registration clutch, CL82-070. Press Start. The jam clearance knob, 4c, PL 80.15 Item 10, rotates. Y↓N→Go to Flag 3. Check CL82-070. Refer to: • GP 12 How to Check a Solenoid or Clutch. • P/J5, IOT PWB. • P/J17 LVPS. • Fuse, PL 1.10 Item 9, GP 7. If necessary install a new registration clutch, (45-55 ppm) PL 80.15 Item 7. If the problem persists, perform OF7 IOT PWB Diagnostics RAP. Enter dC330 code 081-050, bypass feed solenoid, SOL81-050. Press Start. The solenoid energizes. Y↓N→Go to Flag 2. Check SOL81-050. Refer to: • GP 12 How to Check a Solenoid or Clutch. •. • P/J10, IOT PWB. • 301G +24V Distribution RAP. • 301B 0V Distribution RAP. If necessary install a new feed solenoid, PL 70.30 Item 4. If the problem persists, perform OF7 IOT PWB Diagnostics RAP. Perform the following: • Check the registration transport rolls and registration nip rolls, PL 80.15 Item 1. • If the fault still occurs, check the drives plate on the registration clutch for damage and contamination. Refer to the replacement procedure. • Check the idler roll and upper guide on the feed head. • Clean the feed roll and retard pad using a cloth dampened with water. • If necessary install a new feed and retard pad, PL 70.30 Item 21.