Description: Side 1 Scanning Document Size RAP The side 1 scanner has encountered a document that is larger than expected. The side 1 scanner has encountered a document of unknown size. The side 1 document size sensors have incorrectly determined the size of the document.
Remedy: Check that the input module angle sensor actuator is not damaged. If necessary install a new input module angle sensor actuator, PL 60.20 Item 12. Enter dC330 code 062-301 SPDH angle sensor Q62-301, actuate the sensor. The display changes. Y↓N→Check the SPDH angle sensor, Q62-301, refer to: • Flag 1 and • GP 11, How to Check a Sensor • P/J423, Scanner PWB • 301D +3.3V Distribution RAP. • 301B 0V Distribution RAP Install new components as necessary: • SPDH angle sensor, PL 60.20 Item 7 • Scanner PWB, PL 60.20 Item 4 Enter dC330 code 062-019 SPDH platen down sensor Q62-019, actuate the sensor. The display changes. Y↓N→Check the SPDH platen down sensor Q62-019, refer to: • Flag 2 and • GP 11, How to Check a Sensor • P/J423, Scanner PWB • 301D +3.3V Distribution RAP. • 301B 0V Distribution RAP Install new components as necessary: • SPDH platen down sensor, PL 60.20 Item 7 • Scanner PWB, PL 60.20 Item 4 Raise the SPDH. Enter dC330 code 062-251 document size sensor 1, Q62-251. Actuate the sensor by placing a piece of paper on the document glass above the sensor. The display changes. Y↓N→Check the document size sensor 1, Q62-251, refer to: • Flag 3 and • GP 11, How to Check a Sensor • P/J422, Scanner PWB • 301E +5V Distribution RAP • 301B 0V Distribution RAP Install new components as necessary: • Document size sensor 1, Q62-251, PL 60.20 Item 3 • Scanner PWB, PL 60.20 Item 4 Enter dC330 code 062-253 document size sensor 2, Q62-253. Actuate the sensor by placing a piece of paper on the document glass above the sensor. The display changes. Y↓N→Check the document size sensor 2, Q62-253, refer to: • Flag 4 and • GP 11, How to Check a Sensor • P/J422, Scanner PWB • 301E +5V Distribution RAP • 301B 0V Distribution RAP Install new components as necessary: • Document size sensor 2, Q62-253, PL 60.20 Item 3 • Scanner PWB, PL 60.20 Item 4 Go to Flag 5. Disconnect then check the SBC PWB/Scanner PWB data cable and connectors P/J411 on the scanner PWB and P/J250 on the SBC PWB. The data cable and connectors are clean and undamaged. Y↓N→Clean or the connectors. Install new components as necessary: • SBC PWB/Scanner PWB data cable, PL 3.22 Item 20. • Scanner PWB, PL 60.20 Item 4. If the fault remains, perform the 303D SBC PWB Diagnostics RAP. If the problem continues, reload the software using the AltBoot Software Loading Procedure, go to GP 4 Machine Software.